
Calibration
The coast lamp has gone dark. Fit the first shuttle to release its shutter.
- First fit
- The incline
- Cross-check
- Broadside
- The sleeve

The coast lamp has gone dark. Turn the brass shuttle until it fits the slot, then launch.
CALIBRATION / 01
Line up the shuttle’s long edge with the slot, then launch.
Turn the launch dial below. A mirror reverses its tilt after the piece clears the slot.

Drag to aim. Tap − or + to turn 1°.
The fewest launches take first place. If keepers tie, compare their tightest gaps to the nearest tenth.

Each repair opens the next job. You can also start in the Mirror Gallery or the Chart Room.

The coast lamp has gone dark. Fit the first shuttle to release its shutter.

Two supply rails meet beneath the lens. Guide the carrier past their shifted slots.

The lens carriage has lost its bearings. Set its index rings back in step.

The lens brake is still holding. Fit its cable and release pin to send a test beam to the mirror bench.

The silver mirrors carry the beam out to sea. Set their angles for first light.

The tide wheel drives the lamp. Feed its paddles through the high and low sluices.

Set the sextant against the stars and chart the bearing out of the harbour.

Seat the lens, release its shutters and send the first beam over the water.

At −34°, both ends catch. The dashed outline shows how much of the shuttle sits above and below the slot.
Read the collision guide
Silver line sends a nose-up shuttle out nose-down. Read the second slot with that reflected tilt in mind.
Play Silver line
In North sight, turning the dial clockwise sends the first slot counterclockwise. The second slot holds its bearing. Can you find one angle that fits both?
Play North sight